Delta 36-650 Instruction Manual download pdf (Page 16)

10. Using a straight edge, check to see if the saw blade

is aligned with the rear of the splitter (G), as shown in

Fig. 37. If alignment is necessary, loosen the screws (A)

Fig. 37, align splitter (G) with the saw blade, and tighten

two screws (A).

11. Lower saw blade and install table insert (P) Fig. 38,

in the saw table as shown. THE TABLE

INSERT SHOULD BE LEVEL WITH THE TABLE

SURFACE. IF AN ADJUSTMENT IS NECESSARY, SEE

THE SECTION “ADJUSTING TABLE INSERT”.

When installing the table insert, always

make certain to hold on to the blade guard (L). The insert

will automatically release the holding action on the

splitter and lower the blade guard when it is installed in

the table opening.

Fig. 37

Fig. 38

EXTENSION WINGS

1. Assemble extension wing (A) Fig. 39, to the saw

table. Align the three holes in the extension wing with the

three holes in the side of the saw table. Place a 7/16"

lockwasher (C) Fig. 39, onto a 7/16-20x3/4" hex head

screw (B), place a 7/16" flat washer (D) onto the hex

head screw. Insert the screw through the hole in the

extension wing and thread the screw into the tapped

hole in the side of the saw table. Repeat this process for

the two remaining holes in the extension wing and the

saw table.

2. With a straight edge (E) Fig. 39, make certain the

extension wing (A) is level with the saw table before

tightening three screws (B).

3. Assemble the other extension wing to the opposite

end of the saw table in the same manner.

Fig. 39

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

No comments

Delta 36-650 Instruction Manual Page 16