Delta 36-650 Instruction Manual download pdf (Page 20)

RAISING AND LOWERING

THE BLADE

To raise the saw blade, loosen lock knob (A) Fig. 58, and

turn the blade raising handwheel (B) clockwise. When

the blade is at the desired height, tighten lock knob (A).

To lower the blade, loosen lock knob (A) Fig. 58, and turn

the handwheel (B) counterclockwise. NOTE: One full turn

of the handwheel will change blade height approxi-

mately 1/4".

TILTING THE BLADE

To tilt the saw blade for bevel cutting, loosen lock knob

desired blade angle is obtained, tighten lock knob (C).

5. Adjust the pointer (D) Fig. 60, to point to the zero

degree mark on the scale by loosening screw (E),

adjusting pointer (D), and tightening screw (E).

6. Turn the blade tilting handwheel clockwise as far as

it will go and using a combination square, check to see

if the blade is at 45 degrees to the table.

7. If the blade is not at 45 degrees to the table, loosen

set screw (F) Fig. 59, and turn blade tilting handwheel

until you are certain the blade is 45 degrees to the table.

Turn set screw (F) clockwise until it bottoms.

ADJUSTING 90 DEGREE AND

45 DEGREE POSITIVE STOPS

Your saw is equipped with positive stops that will quickly

and accurately position the saw blade at 90 degrees and

45 degrees to the table. To check and adjust the positive

stops, proceed as follows:

DISCONNECT MACHINE FROM POWER

SOURCE.

1. Raise the saw blade to its highest position.

2. Set the blade at 90 degrees to the table by turning

the blade tilting handwheel counterclockwise as far as it

will go.

3. Using a combination square (A) Fig. 59, check to

see if the blade is at 90 degrees to the table surface as

shown.

4. If the blade is not at 90 degrees to the table, loosen

set screw (B) Fig. 59 with supplied wrench (C), and turn

the blade tilting handwheel until you are certain the

blade is at 90 degrees to the table. Turn set screw (B)

clockwise until it bottoms.

Fig. 58

Fig. 59

Fig. 60

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Comments to this Manuals

No comments

Delta 36-650 Instruction Manual Page 20

Comments to this Manuals

Related products and manuals for Power tools Delta 36-650