INSTRUCTION MANUALPART NO. 1346942 - 03-30-05Copyright © 2005 Delta MachineryStock Feeder(Model 36-850)To learn more about DELTA MACHINERY visit our w
10MOTOR CONTROL SPEED SWITCHTo operate the feeder in a forward position, turn switch(A) Fig. 7 clockwise. To operate the feeder in the oppo-site direc
11Position the feeder assembly (A) Fig. 10 on a table sawso that the saw blade is between the middle roller (B)and the outfeed roller (C) and slightly
12TROUBLESHOOTINGFor assistance with your machine, visit our website at www.deltamachinery.comfor a list of service centers or callthe DELTA Machinery
13Two Year Limited New Product WarrantyDelta will repair or replace, at its expense and at its option, any new Delta machine, machine part, or machine
14NOTES
15NOTES
The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE • DELTA S.A.) (Les marquessuivantes sont de
2TABLE OF CONTENTSRead and understand all warnings and operating instructions before using any tool or equipment. Whenusing tools or equipment, basic
3Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.Indicates a potentially hazardous situation
4GENERAL SAFETY RULESREAD AND UNDERSTAND ALL WARNINGS AND OPERATING INSTRUCTIONS BEFOREUSING THIS EQUIPMENT. Failure to follow all instructions listed
5FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.ADDITIONAL SPECIFIC SAFETY RULESSAVE THESE INSTRUCTIONS. Refer to them often and
6A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected with a 20 Amp ti
7EXTENSION CORDSUse proper extension cords. Make sureyour extension cord is in good condition and is a 3-wire extension cord which has a 3-prong groun
81. Position the mounting bracket (A) Fig. 2 at thedesired location on the machine.2. Mark the locations (B) where the four mountingholes are to be dr
9FEED RATE ADJUSTMENTSFeed rates of 14, 26, 33, and 63 feet per minute (or 4, 8,10 and 19 meters per minute) are available with thestock feeder. A gea
Comments to this Manuals