WWW.DELTAMACHINERY.COM(800) 223-7278 - US(800) 463-3582 - CANADA10" Contractors Saw(Model 36-978/36-979)Acepilladora Portátil12½" pulgadasRa
10LOCKING SWITCH IN THE "OFF" POSITIONIMPORTANT: When the machine is not in use, the switch should be locked in the "OFF" position
11LEVELING EXTENSION TABLESThe extension tables (A) and (G) Fig. 14 must be level with the planer table. To check the extension tables and adjust if n
12CARRYING HANDLE/STOCK TRANSFER BAR1. Your planer is provided with a foam covered carrying handle (A) Fig. 17, located on top of the machine, for ea
134. Insert knife transfer tool (G) Fig. 21, underneathcenter of knife. Lift the knife transfer tool up until knife (H) separates from pins (J) and p
14When using your machine, follow these few simple steps for achieving the best results.1. True Up One Face – Feed one face of the board over a joint
15BRUSH INSPECTION AND REPLACEMENTDisconnect tool from power sourceBrush life varies. It depends on the load on the motor. Check the brushes after the
16REPLACEMENT PARTSUse only identical replacement parts. For a parts list or to order parts, visit our website at servicenet.deltamachinery.com. You c
The following are trademarks of PORTER-CABLE • DELTA (Las siguientes son marcas registradas de PORTER-CABLE • DELTA S.A.) (Les marques suivantes sont
2Read and understand all warnings and operating instructions before using any tool or equipment. When using tools or equipment, basic safety precauti
3It is important for you to read and understand this manual. The information it contains relates to protecting YOUR SAFETY and PREVENTING PROBLEMS. Th
41. FOR YOUR OWN SAFETY, READ THE INSTRUCTION MANUAL BEFORE OPERATING THE MACHINE. Learning the machine’s application, limitations, and specific haza
51. DO NOT OPERATE THIS MACHINE until it is completely assembled and installed according to the instructions. A machine incorrectly assembled can cau
6Fig. A Fig. BGROUNDED OUTLET BOXCURRENTCARRYINGPRONGSGROUNDING BLADEIS LONGEST OF THE 3 BLADESGROUNDED OUTLET BOXGROUNDING MEANSADAPTERPOWER CONNECTI
71. Planer2. Cutterhead Guard3. Knife Transfer Tool4. 5mm Wrench Assembly5. M5 x 20mm Hex Socket Head Screw6. M5x10mm Knob (2)7. Elevating Handle1
8For your own safety, do not connect the machine to the power source until the machine is completely assembled and you read and understand the entire
9CUTTERHEAD GUARD1. Attach the cutterhead guard (A) Fig. 7 to the planer by inserting the end of the guard over the top of the cutterhead. Place the
Comments to this Manuals