Delta 43-459 Instruction Manual Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
7
Fig. 8
ATTACHING TABLE INSERTS
Three table inserts are provided for various size cutters (Fig. 8). The large insert is adjustable.
To set it flush with the table:
1. Remove the three slotted head screws (A) Fig. 8.
2. Use a screwdriver to turn the three adjusting screws (B) Fig.8 until the insert is flush with
the table.
3. Replace the slotted head screws (A).
1. Six collars (A) Fig. 9 are supplied with the machine. These collars allow the cutter and/or the 6-1/2" diameter spindle
guard to be positioned at various locations on the spindle.
2. When attaching cutters to the spindle, position the cutter as close to the bottom of the spindle as possible to reduce
the possibility of spindle run-out, which can affect the appearance of the cut.
3. Determine which, if any, collars are needed. Then attach the cutter (B) Fig. 9, keyed washer (C), and spindle nut (D) Fig.
9). Place one wrench on the flats (A) Fig. 10 on top of the spindle and one wrench on the spindle nut (D). Tighten as
shown in Fig. 11.
4. IMPORTANT: Always place “keyed” washer (C) Fig. 10, on spindle before screwing on nut (D). The “keyed” washer
(C) prevents the nut (D), from loosening when spindle turns counterclockwise.
ATTACHING CUTTERS AND COLLARS TO SPINDLE
DISCONNECT MACHINE FROM POWER SOURCE.
Fig. 9
A
C
A
Fig. 10
A
D
C
B
Fig. 11
1. Two 1-1/4" I.D. washers are supplied with the 6-1/2" spindle guard. Place one of the washers (A) on the spindle (Fig.12).
2. Place the spindle guard (B) Fig. 13 on the spindle. Install the other washer (C) and the “keyed” washer (D) on the spindle.
3. Thread the spindle nut (E) Fig. 14 on the spindle. Place one wrench on the flats at the top of the spindle and one wrench
on spindle nut (E) and tighten.
4. IMPORTANT: Always place the “keyed” washer (D) Fig. 13, on the spindle before screwing on the spindle nut (E)
Fig. 14. The “keyed” washer (D) Fig.19 prevents the spindle nut (E) Fig. 14 from loosening when the spindle turns
counterclockwise.
B
C
D
A
E
DISCONNECT MACHINE FROM POWER SOURCE.
Fig. 12
Fig. 13
Fig. 14
D
ATTACHING SPINDLE GUARD
A 6-1/2" spindle guard is supplied with this machine.
The diameter of the spindle guard should be at least 1" more than the maximum cutting circle of
the shaper cutter and the height of the guard should not exceed 1/4" above the material.
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comments to this Manuals

No comments