Delta 900585 Instruction Manual download pdf (Page 6)

Fig. 7

Fig. 8

Fig. 9

Fig. 10

4. Place the drill press head (F) Fig. 7, onto the column

(A) as far as it will go. Align head to table and base and

tighten the two head locking screws (G) with wrench

supplied.

5. Thread the three pinion shaft handles (H) Fig. 8, into

the three holes located in the pinion shaft (J) as shown.

6. IMPORTANT: The spindle taper (K) Fig. 9, and the

tapered hole (L) in the chuck (M) are coated with a clear

rust protectant and will require a solvent to remove the

coating. These surfaces must be clean to ensure that the

chuck will adhere to the spindle and will not come loose

during operation. NOTE: Household oven cleaner can

effectively remove the rust protectant coating from the

spindle and chuck; however, carefully follow the

manufacturer’s safety rules concerning its use. Then

push the chuck (M) up on the spindle (K) as far as it will

go.

7. IMPORTANT: Open the chuck jaws as wide as

possible by turning the chuck sleeve (M) Fig. 10.

8. Holding chuck on taper of spindle, tap with a mallet

(N) or a block of wood and hammer to set chuck, as

shown in Fig. 10. IMPORTANT: To avoid damage to the

chuck, NEVER drive the chuck onto the spindle with a

metal hammer.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

No comments

Delta 900585 Instruction Manual Page 6