Delta 900585 Instruction Manual download pdf (Page 9)

Fig. 18

Fig. 19

Fig. 20

Fig. 21

STARTING AND

STOPPING DRILL PRESS

The switch (A) Fig. 18, is located on the front of the drill

press head. To turn the drill press “ON” move the switch

to the up position. To turn the drill press “OFF” move the

switch to the down position.

LOCKING SWITCH IN

THE “OFF” POSITION

When the tool is not in use, the switch should be locked

in the “OFF” position to prevent unauthorized use of the

tool. To lock the switch in the “OFF” position, grasp the

switch toggle (B) and pull it out of the switch, as shown

in Fig. 19. With the switch toggle (B) removed, the switch

will not operate. However, should the switch toggle be

removed while the drill press is operating, the switch can

be turned “OFF” once, but cannot be restarted without

inserting the switch toggle (B).

TABLE ADJUSTMENTS

1. The table can be raised or lowered on the drill press

column by loosening the table clamp handle (A) Fig. 20.

Move the table to the desired position on the column

and tighten table clamp handle (A).

2. The table can be tilted right or left by pulling out and

removing table alignment pin (B) Fig. 21. NOTE: If pin (B)

is difficult to remove, turn nut (C) clockwise to pull pin

out of casting.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Delta 900585 Instruction Manual Page 9