Delta DP200 Instruction Manual

INSTRUCTION MANUAL10" Bench Drill Press(Model DP200)PART NO. 906770 - 07-01-02Copyright © 2002 Delta MachineryESPAÑOL: PÁGINA 17To learn more abo

10Fig. 15Fig. 16RQST10. IMPORTANT: Make certain the spindle taper (Q) Fig.15, and tapered hole in chuck (R) are clean and free ofany grease, lacquer o

11LOCKING SWITCH IN THE “OFF” POSITIONIMPORTANT: When the machine is not in use, theswitch should be locked in the “OFF” position to preventunauthoriz

12Fig. 22 Fig. 23Fig. 243. The table can be tilted right or left by pulling out andremoving table alignment pin (C) Fig. 22. NOTE: If pin (C)is diffic

13Fig. 27DRILLING HOLES TO DEPTHWhere a number of holes are to be drilled to exactly thesame depth, a depth stop is provided in the pinion shafthousin

14OPERATIONYour drill press is to be used with drill bits with a shank of 1/2" or less in diameter. The following will give the inexperiencedoper

15CORRECT DRILLING SPEEDSFactors which determine the best speed to use are: kind of material being worked, size of hole, type of drill or othercutter,

Two Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory whichin

2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain ha

3ADDITIONAL SAFETY RULES FORFOR DRILL PRESSES1. DO NOT OPERATE THIS TOOL UNTIL it isassembled and installed according to theinstructions.2. OBTAIN ADV

4POWER CONNECTIONSA separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected

Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord whichhas a 3-prong grounding type plug a

6DRILL PRESS PARTSFig. 21 - Drill Press Head and Motor2 - Table Raising and Lowering Handle3 - Table Clamp4 - Chuck 5 - Chuck Key6 - Pinon Shaft Handl

7ASSEMBLYWARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THEMACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERS

8Fig. 7Fig. 8Fig. 9Fig. 10GKLFFJDEF4. Slide raising rack (F) Fig. 7, table and table bracketonto drill press column, as shown. Make sure bottom ofrais

9Fig. 12Fig. 13Fig. 14MNOP7. Thread stud on clamp handle (M) Fig. 12, into hole inrear of table bracket, as shown.8. Place the drill press head (N) Fi