Delta DVP-ES2 User Manual Page 683

  • Download
  • Add to my manuals
  • Print
  • Page
    / 702
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 682
7 CANopen Function and Operation
7-27
Code Indication How to correct
F4 BUS-OFF state is detected.
Check if CANopen bus cables are properly
connected and ensure that all the node
devices run at the same baud rate before
re-powering.
FB
The sending buffer in
DVP-ES2-C is full.
Check if the CANopen bus cable is properly
connected and then re-power.
FC
The receiving buffer in
DVP-ES2-C is full.
Check if the CANopen bus cable is properly
connected and then re-power.
7.6 Application Example
DVP-ES2-C is used to control Delta A2 servo rotation and monitor the actual rotation speed of
motor in real time. The principle of operation is to map the relevant parameters of servo drive to the
corresponding PDO and read or write the relevant parameters of servo drive through the CAN bus
to accomplish the control requirement.
¾ Hareware Connection:
DVP32ES2-C
PC
TAP-CN03
Y5UP 0 Y0 Y1 Y3Y2 Y4 Y10Y7Y6 UP 1 Y12Y11 Y13
+24V
L N NC X5X1S/S24G X0 X3X2 X4 X11X7X6 X10 X13X12 X14 X15
Y16Y15Y14
Y17
X17X16
ZP1ZP0CA N+ SG
+
DD
-
CAN-
ASDA-A2-xxxx-M
CANopen
CANopen
RS-232
Note:
1. We recommend user use the standard communication cable TAP-CB01/TAP-CB02/ TAP-CB10
and connect the terminal resistors such as Delta standard terminal resistor TAP-TR01 to either
terminal of the network when constructing the network.
2. TAP-CN03 is a distribution box and the resistance it has can be effective after its SW1 is
switched to ON. According to actual demand, user could select TAP-CN01/CN02/CN03 for
wiring.
3. M of ASD-A2-xxxx-M refers to the model code and currently only the M-model servo supports
CANopen communication.
¾ Setting Servo Parameters:
Set servo parameters as follows:
Parameter Setting Explanation
3-00 02 The Node ID of A2 servo is 2
3-01 400 CAN communication rate is 1Mbps.
Page view 682
1 2 ... 678 679 680 681 682 683 684 685 686 687 688 ... 701 702

Comments to this Manuals

No comments