Delta AH500 series Manual Page 219

  • Download
  • Add to my manuals
  • Print
  • Page
    / 297
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 218
AH500 Hardware Manual
5-61
corresponding to x16
1
to position 1, and turn the knob corresponding to x16
0
to position A.
26 (decimal value)1A (hexadecimal value)=1×16
1
A×16
0
Points for attention:
If users set the node address of AHRTU-PFBS-5A when AHRTU-PFBS-5A is not supplied with power, they
have to power AHRTU-PFBS-5A after the node address of AHRTU-PFBS-5A is set.
If users change the node address of AHRTU-PFBS-5A when AHRTU-PFBS-5A is powered, the change will
not take effect immediately after the node address of AHRTU-PFBS-5A is changed, and it will take effect
after the users cut off the power supplied to AHRTU-PFBS-5A and then power AHRTU-PFBS-5A again.
To prevent the address knobs on AHRTU-PFBS-5A from being scratched, please carefully use a slotted
screwdriver to rotate the address knobs on AHRTU-PFBS-5A.
5.9.3 Wiring AHAADP01EF-5A/AHAADP02EF-5A
5.9.3.1 Connecting 100BASE-FX Fibers
AHAADP01EF-5
A
A
HAADP02EF-5
A
TX
RX
TX
RX
5.9.3.2 Specifications for Cables
SC, multimode fiber, 62.5/125 μm
SC, multimode fiber, 50/125 μm
5.9.3.3 Installing AHAADP01EF-5A/AHAADP02EF-5A on a Backplane
The connector of AHAADP01EF-5A must be connected to the lower extension port of a backplane. The
connector of AHAADP02EF-5A must be connected to the upper extension port of a backplane.
Points for attention:
When users install AHAADP01EF-5A/AHAADP02EF-5A on a backplane, they have to make sure that
AHAADP01EF-5A/AHAADP02EF-5A is connected to an extension port of the backplane correctly.
(AHAADP01EF-5A must be connected to the lower extension port of the backplane, and
AHAADP02EF-5A must be connected to the upper extension port of the backplane.) Otherwise, an error
will occur if a CPU module connects to AHAADP01EF-5A/AHAADP02EF-5A.
Page view 218
1 2 ... 214 215 216 217 218 219 220 221 222 223 224 ... 296 297

Comments to this Manuals

No comments