Delta 18-900L Use and Care Manual Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 68
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
16
CHECKING LASER ADJUSTMENT
To reduce the risk of injury, turn unit off
and disconnect it from power source before installing
and removing accessories, before adjusting or when
making repairs. Anaccidentalstart-upcancauseinjury.
LASER LIGHT. Do not stare into the
beam, aperture, or into a reflection from a mirror-like
surface.
Laser alignment is preset at the factory. If needed, the
alignment can be adjusted by following the steps below:
To check if the lasers are perpendicular to the table,
do this:
1. Usingacarpenter'ssquareorsimilardevice,drawa
straightline(C1)Fig.34onascrapboard.
2. Place board on its edge as shown in Fig. 34 with
line facing back of drill press. Make sure the board
is placed over the middle of the table insert (D1)
Fig.34,asshown.
3. Turn laser on so the red lines are shining on board as
shown.Checktoseeifbothredlines(E1)Fig.34are
parallelwiththeline(C1)youdrew.
If they are not:
1. Using an included hex key, turn the front screw
(F1)Fig.35ontherightlaserpodsothatitsredline
is parallel with the line you drew on the board.
2. Repeat this step for the left laser pod and its line
usingitsfrontscrew(F1)Fig.36.
To check to see if the lasers intersect at the drill
point:
1. Layboardatontable(Fig.37)andmakesureitdoes
not move.
2. Usingasmalldrillbitwiththemachineoff,lowerthe
drill bit and make an impression in the board.
3. For both lasers, use the same hex key in the the
backscrew(G1)(Fig.35and36)anddialthelasers
so they both cross this point together, as shown in
Figure37.
C1
Fig. 34
D1
E1
E1
Fig. 35
Fig. 36
Fig. 37
F1
G1
F1
G1
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 67 68

Comments to this Manuals

No comments