8
29" (737 mm) MINIMUM
24" (610 mm) MINIMUM
ATTACHING DRILL PRESS
TO SUPPORTING SURFACE
1. If you plan to use your drill press in a permanent
location, you must secure the drill press base to
thesupportingsurfacewithfasteners(notsupplied)
throughthefourmountingholes(A)Fig.1inthedrill
press base.
NOTE: To attach the base to the plywood, use the
following hardware: (4)M8x1.25x125mmcarriagehead
screws, (8)M8 at washers, (4)M8 lockwashers, and
(4)M8x1.25hexnuts.
RISK OF UNSAFE OPERATION. If your
drill press is not permanently fastened to the floor
it may be mounted to a plywood board to improve
stability and prevent tipping.
RISK OF UNSAFE OPERATION. Use a
good grade of plywood with a minimum 3/4" (19 mm)
thickness. Do not make the mounting board from
particle board since particle board breaks easily.
2. Use a plywood board base with the minimum
dimensionsasshowninFig.2formountingthedrill
pressbase(B)Fig.1toasupportingsurface.
3. Placethedrillpressbasecenteredontheplywood(D).
RISK OF UNSAFE OPERATION. Make
sure that the plywood extends a minimum of 3"
(76.2 mm) on all four sides of the base.
4. Markfourholes(C)Fig.2throughtheholes(A)Fig.
1 in the drill press base. Then drill 3/8" (9.5 mm)
diameter holes at these locations into the supporting
surface(D)Fig.2.
NOTE: Place a piece of scrap wood underneath the
supporting plywood surface when drilling the through
holes so that the drill bit will not damage the material
beneath the plywood supporting surface.
5. Fastenthedrillpressbasetothemountingplywood
board using the carriage bolts, at washers,
lockwashers, and hex nuts described above (not
supplied). Countersink the holes for the carriage
boltheadsandatwashersundertheboardsothat
the bolt heads are ush with or below the bottom
surface of the board after you insert them up through
the holes below the supporting surface. Use a at
washer, lock washer and hex nut above the drill
press base to fasten the screws.
ASSEMBLY TOOLS REQUIRED
Hexwrenches(supplied)
Rubbermallet(notsupplied)
10mmwrench
Fig. 2
C
ASSEMBLY
To reduce the risk of injury, turn unit off and disconnect it from power source before installing and
removing accessories, before adjusting or when making repairs. An accidental start-up can cause injury.
ASSEMBLY TIME ESTIMATE
Assemblyforthismachinetakesapproximately30
minutesto1hour.
C
D
Fig. 1
A
A
B
Comments to this Manuals