9
ASSEMBLING DRILL PRESS PARTS
RISK OF UNSAFE OPERATION. If your
drill press is not permanently fastened to the floor
it may be mounted to a plywood board to improve
stability and prevent tipping.
To reduce the risk of injury, turn unit off
and disconnect it from power source before installing
and removing accessories, before adjusting or when
making repairs. Anaccidentalstart-upcancauseinjury.
1. Attachthecolumn(E)Fig.3tothebase(B)usingthe
fourM10x40mmsocketheadcapscrews(F),threeof
which are shown.
NOTE: Makesurescrew(G)(Fig.3inset)isorientedtothe
back of the drill press.
2. Attach the table raising and lowering handle(H)Fig.4to
thewormgearshaft(I).Tightenthesetscrew(J)against
theatontheshaftwiththe3mmhexwrenchsupplied.
3. Threadthetableclamphandle(K)Fig.5inthehole(L)
in rear of table bracket and secure tightly.
4. Alignthebolts(M)Fig.6onthetable(Q)withtheholes
inthetablesupport(N)andsetthetableonthetable
supports.
NOTE: Be sure to properly orient your drill press table to the
columnasshowninFig.6A.
5. Install the washers and forward tilt knobs as shown in
Fig.7.Tightensecurely.
NOTE: The bolts in the trunnion are moveable. To install
knobsmoreeasily,insertaatheadscrewdriver(O)Fig.8in
the opening of the trunnion against the bolts to steady them.
Fig. 3
Fig. 4
F
B
F
H
I
J
G
E
Fig. 5
K
L
M
M
N
N
Fig. 6
Fig. 6A
Q
Fig. 7
Fig. 8
O
Comments to this Manuals