HIGH-RISE, PULL-DOWN KITCHEN AND BAR / PREP, TOUCH FAUCETSLLAVES DE AGUA ELEVADAS, DESLIZABLES HACIA ABAJO, PARA COCINAS Y BARES /
A.1063218 Rev. CA. Connect battery cable (1) to battery box (2). Install 6 “AA” batteries (3) into the battery box (2). Important: DO NOT install
1163218 Rev. C422312A.D.412B.C.12OROOU314D. Custom Fit ConnectionsIf you determine the PEX supply tubing for this faucet is too long and must be
1263218 Rev. CCustom Fit Connections - Plastic Sleeve Installation Instructions 1. Identify desired length of tube (1). Leave 1" - 2" o
6A. Turn on hot and cold water supplies (1). Pull the hose assembly (2) out of the spout and remove the spray head (3). Be sure to hold the end of t
1463218 Rev. CCheck the operation of the 2 function wand by pushing the trigger from aerator to spray. For models with a 3 function wand, check t
Low Battery IndicationWarning Mode - Replace batteries soon. - Rather than the BLUE LED (1), the RED LED will be illuminated when the water is ON. Whe
1663218 Rev. CSolenoid Troubleshooting1. If your spout flashes a red light on then off and then keeps repeating this, replace the batteries.
263218 Rev. CCleaning and CareCare should be given to the cleaning of this product. Although its finish is extremely durable, it can be damaged b
RP53879▲ButtonBotónBoutonRP60520 Adapter & O-RingAdaptador y Aro-OAdaptateur et joint toriqueRP60976▲ Sprayer Assembly (includes aerat
Other useful accessories that may be purchased separately.Otros accesorios útiles que se pueden comprar por separado.Autres accessoires utiles pouvant
563218 Rev. C1Spout Installation For Top Mount SinksA. Your faucet is designed for a hole diameter of 1 3/8" +/- 1/8" (35 mm +/- 3 mm
663218 Rev. C11 1/4" Min. From Center Line To Sink Bowl.1 1/4" Mínimo. De la línea de centro para hundir el tazón de fuente.1 1/4"
763218 Rev. CAssemble adapter (1) and solenoid (2) together using clip (3). Then slide adapter/solenoid assembly onto tube (4) and snap on swing
A-1C.B. Remove hose guide and slide hose weight (1) over end of hose (2). C. Push hose end (1) onto solenoid assembly outlet (2). Attach clip (3) ove
B.Wire ConnectionsConexiones de AlambreBranchement des fils13A. Briefly touch the cold stop or other ground with hand to dissipate any static charge.
Comments to this Manuals