Delta MMC120 User Manual download pdf (Page 89)

MMC120 Linear Motion Control Module Appendix A: DCS120

Delta Computer Systems, Inc. 360/254-8688 89

[READBACK]

The [READBACK] parameter determines whether DCS120 starts up in the Readback mode or Write mode. The

following configuration allows you to execute DCS120 and to come up in the readback mode without initializing the

axis:

[FORCEINIT] NO ; DEFAULT

[READBACK] YES ; DEFAULT

This configuration allows DCS120 to initialize all axes and come up in the readback mode:

[FORCEINIT] YES

[READBACK] YES ; DEFAULT

[LOOKONLY]

This keyword controls access to the initialization and command parameters. When [LOOKONLY] is set to YES,

DCS120 can only monitor status and plot graphs. When it is NO all capabilities are enabled.

[BOARD]

This keyword has one parameters: the module name. This name is displayed in the upper right corner of the main and

graph screens. This name is limited to six characters. It can be edited to reflect the function of the module, such as

edger, or qdbnd.

[AXIS]

This keyword has only one parameter: the name of the axis. The axis name can be up to five characters long; longer

names are truncated. The name can be chosen to indicate the function of the axis. There must be two axis keywords

immediately after each board keyword.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 104 105

No comments

Delta MMC120 User Manual Page 89