Delta RMC101 User Manual download pdf (Page 112)

100

101

RMC100 and RMCWin User Manual

3-62

Axis: Select the axis for the status you want to display.

Field: Select the status field for the selected axis that you want to display.

• Parameter

This area gives access to most of the parameters on any axis. These fields may be read only or

editable. Changes made to parameters take effect immediately and do not require a separate Set

Parameters (P) command to be issued. This area has the following additional parameters that

must be defined:

Axis: Select the axis for the parameter you want to display.

Field: Select the parameter for the selected axis that you want to display. Notice that the

Configuration Word and Auto Stop parameters cannot be displayed or edited.

Note: When parameters are changed through the LCD420 display, the Set Parameter On-the-

Fly (0xD0-0xDF) commands are used internally. Not all parameters can be set on-the-fly and

therefore, attempting to change them will result in a parameter error. For details on limitations of

setting parameters on-the-fly, see Set Parameter On-the-Fly Commands.

• Step Table

This area gives access to most fields in the Event Step table. These fields may be read only or

editable. This area has the following additional parameters that must be defined:

Step: Select the step number for the field you want to display.

Field: Select the step field you want to display. Notice that the Mode, Command, Commanded

Axes, Link Type, and Link Next fields cannot be displayed or edited.

• Profile Table

This area gives access to most fields in the Motion Profile table. These fields may be read only or

editable. This area has the following additional parameters that must be defined:

Profile: Select the profile number for the field you want to display.

Field: Select the profile field you want to display. Notice that the Mode field cannot be displayed or

edited.

• Input-to-Event Table

This area gives access to any Input-to-Event table entry. These fields may be read only or

editable. Blank Input-to-Event table entries will be displayed as -1. This area has the following

additional parameters that must be defined:

Axis: Select the axis for the input-to-event table entry you want to display.

Input: Select the input edge for the input-to-event table entry you want to display.

• Parameter Error

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 950 951

Comments to this Manuals

No comments

Delta RMC101 User Manual Page 112

Comments to this Manuals

Related products and manuals for Sensors Delta RMC101