Delta RMC101 User Manual Page 624

  • Download
  • Add to my manuals
  • Print
  • Page
    / 951
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 623
RMC100 and RMCWin User Manual
7-0
7 Support and Troubleshooting
7.1 Warranty
The RMC100 shall be free from defects in materials and workmanship under normal and proper
use and service for a period of fifteen (15) months from the date of shipment by Delta Computer
Systems, Inc. (Delta) or Delta's authorized distributor so long as the module was under warranty
when shipped to the customer by the distributor.
The obligation of Delta under this warranty shall be limited to repairing or replacing this motion
controller or any part thereof which, in the opinion of Delta, shall be proved defective in materials
or workmanship under normal use and service during the warranty period.
Repairs required because of obvious installation failures (burned resistors, traces, etc.) are not
covered and will be billed at standard repair rates.
Disclaimer of other Warranties: There are no other representations or warranties made by
Delta, express or implied. Delta expressly disclaims any and all implied warranties,
including any implied warranty of merchantability and any implied warranty of fitness for a
particular purpose. Further, Delta disclaims any liability for special, consequential or incidental
damages resulting from any breach of warranty by Delta under this Agreement.
RMC Return for Repair
Should an RMCrequire repair, refer to Technical Support for return details.
7.2 Troubleshooting
7.2.1 Programming Hints
The Programmable Controller is responsible for storing the initialization parameters used by the
RMC and initializing the RMC with those parameters.
The RMC provides a Status word for each axis. If an error bit is enabled in the Status word, the
Programmable Controller is responsible for shutting down the axis drive power. It must have a
watchdog timer that will shut down the drives if a time-out occurs.
The PC should write to the RMC only once per scan, otherwise the newest data will overwrite the
previous data.
Page view 623
1 2 ... 619 620 621 622 623 624 625 626 627 628 629 ... 950 951

Comments to this Manuals

No comments