Appendix A: Command Reference
A-37
Hex E =
A =
8 =
2 =
Note: The above discussion on determining the correct hexadecimal number to turn on one or
more outputs applies also to the Reset Outputs command. The only difference is that the outputs
represented by a binary ’r;1’ are turned off instead of on.
See also: Reset Outputs
A.1.52 Simulate Rising Edge Command
Character: {
Decimal: 123
Hexadecimal: 0x7B
Command Value: Input to Simulate in Input-to-Event Table
Note: This command is supported in RMC100 CPU firmware dated 19980331 or later.
Comments to this Manuals