Delta RMC101 User Manual download pdf (Page 901)

100

101

Appendix E: Event Step Link Reference

E-11

even if you do), you should use the Link Type and Link Value dialog box to edit these link types.

• If you selected a link type of '{ ', '}', '[', or ']', each of the sixteen bits (number 0 to 15, right to

left) correspond to the sixteen inputs. Enter a 1 in each input's bit to that you care about (e.g.,

if you want inputs 2 and 4 to be off, the link value should be 0x000A).

• If you selected a link type of '\' or '|', then bits 0-7 correspond to the OFF level of inputs 0-7.

Enter 1's in the bits of the inputs that must being OFF. Bits 8-15 correspond to the ON level

of inputs 0-7. Enter 1's in the bits of the inputs that must be ON.

Example 1:

Link Type: InpAllMIX

Link Value: 0x0803

Link Next: 11

This link will check inputs 0, 1 and 3. Input bits 0 and 1 must be off and input bit 3 must be on

before going to the next step.

Example 2:

Link Type: InpAnyMIX

Link Value: 0x0803

Link Next: 11

This link will check inputs 0, 1 and 3. If input bit 0 is off, bit 1 is off, or bit 3 is on then execute

the next state.

E.4.6 Link Type - Inputs, Single (Level/Edge)

Link

Type:

InputRise (I, hex 0x49, dec 73) - Rising Edge

InputFall (i, hex 0x69, dec 105) - Falling Edge

InputHigh (O, hex 0x4F, dec 79) - Level High

InputLow (o, hex 0x6F, dec 111) - Level Low

Link

Value:

Discrete Input number to wait for

Range:

Depends on Configuration

Note: The input level portion of these link types is available only in RMC100 CPU firmware

version 19990625 and later.

Note: The Rising (I) and Falling Edge (i) link types should not be used with the Poll (?)

command. This is because the edges can be missed during the polling cycle since these link

types only check for an edge in the last control loop. You should instead use the Level High (O)

1 2 ... 896 897 898 899 900 901 902 903 904 905 906 ... 950 951

Comments to this Manuals

No comments

Delta RMC101 User Manual Page 901

Comments to this Manuals

Related products and manuals for Sensors Delta RMC101