Delta F-25 User Manual download pdf (Page 11)

10.1 DMX Addresses:

DELTA 10 F can be used in 3 different DMX modes: 10 DMX control channels, 6 DMX control channels or

CUSTOM mode channels.

Here below is described the DMX channels addressing for the controller when Delta 10 f is set to

10 DMX control channels :

Projector 1 A001

Projector 2 A011 If you want to select the next projector, just add “10”

Projector 3 A021

….. A….

projector 6 A051

10.2 Selelcting the DMX address:

1) Press the UP-DOWN key until you reach the required DMX address. The numbers on the display will

start to flash (but the new DMX address hasn't yet been set).

2) Press ENTER to confirm your selection. The numbers on the display will stop flashing and the

projector is now controlled by the new DMX address.

TIPS: if you keep pushed the UP or DOWN keys, the channels are calculated more quickly and you get

a faster selection.

Please refer to an authorised D.T.S. service centre.

D.T.S. Firmware upgrade utility program.

D.T.S. Firmware upgrade utility

11 FIRMWARE UPDATING

Warning:

This procedure require a base knolewge of computer applications and Windows

Hyperterminal program.

To update the software version of the DELTA 10 F you need:

D.T.S. RED BOX interface (D.T.S. Code: 03.LA.008).

USB-DMX Driver for the D.T.S. RED BOX interface .

(The driver and the installation procedure are available in our web site www.dts-lighting.it)

Updating the software version.

Please follow the procedure below to perform the update:

1. Install the D.T.S. RED BOX USB-DMX driver on the PC you will use to update the unit software.

2. Connect the D.T.S. RED BOX interface to the PC by using a USB cable.

3. Connect the D.T.S. RED BOX interface to the fixture by using a DMX cable.

4. Download the new software version into the unit by using program.

It will be possible to download the software from the reserved area of D.T.S. web site:

www.dts-lighting.it.

DELTA 10 F

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

No comments

Delta F-25 User Manual Page 11