Delta PG-35 User Manual download pdf (Page 41)

11-13

CONTROL SYSTEM

SM DELTAZ 1-E.0 GB

11.11.2 Outdoor Unit Controller

11.11.2.1 Hardware Jumpers

JP9 JUMPER LAYOUT

EEPROM Data (PIN 9) ODU3 (PIN 7) ODU2 (PIN 5) ODU1 (PIN 3) ODU0 (PIN 1)

GND (PIN 10) GND (PIN 8) GND (PIN 6) GND (PIN 4) GND (PIN 2)

ODU MODEL SELECTION

ODU3 ODU2 ODU1 ODU0 ODU Model Compressor Type

OFF OFF OFF OFF Reserved

OFF OFF OFF ON A (Single DCR 22- Use Capillary) Toshiba-DA89 (4 Poles)

OFF OFF ON OFF B (Single DCR 25- Use Capillary) Toshiba-DA89 (4 Poles)

OFF OFF ON ON C (Single DCR 35- Use Capillary) Toshiba- DA108 (4 Poles)

OFF ON OFF OFF D (Reserved)

OFF ON OFF ON E (Single DCR 22- Use EEV) Panasonic-5RS092 (6 Poles)

OFF ON ON OFF F (Single DCR 25- Use EEV) Panasonic-5RS092 (6 Poles)

OFF ON ON ON G (Single DCR 35- Use EEV) Panasonic-5RS102(6 Poles)

ON OFF OFF OFF H

ON OFF OFF ON I

ON OFF ON OFF J

ON OFF ON ON K

ON ON OFF OFF L

ON ON OFF ON M

ON ON ON OFF N

ON ON ON ON O

PCB JUMPER SETTING FOR J2 HEAD

RXD (PIN 2) TEST (PIN 4) GND (PIN 6)

VCC (PIN 1) N/C (PIN 3) TXD100 (PIN 5)

1. Connect PIN 4 and PIN 6 to enter Buit-in-Test.

2. RXD, TXD100, VCC is for MegaTools connection.

PCB JUMPER J1 HEADER

J1 header is used for program flash.

11.11.2.2 Software Jumpers

Property 0 1

EEPROM DATA (J1) Use ROM* Use EEPROM

* Default values (used in the ROM)

J1 – EEPROM/ROM setting

When J1 is 1, ODU will use model/general parameters from EEPROM. If EEPROM is invalid, ODU

will ignore J1 and use/copy the ROM pointed by the selected jumpers (will also set an according

fault).

CONTENTS

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 54 55

No comments

Delta PG-35 User Manual Page 41