Delta SM600 User Manual download pdf (Page 11)

TABLE INSERT

The table insert (A) can be assembled to the saw table

with the opening in the insert pointing to the front of the

table, as shown in Fig. 19, or to the right as shown in Fig.

20.

With the table in the level position, 90 degrees to the

blade, the insert should be positioned, as shown in Fig.

19. This allows for the blade to be pivoted forward after it

is unclasped from the top blade holder, enabling you to

quickly insert the blade into the next hole in a pattern

when doing inside-cutting.

When tilting the table for bevel cutting operations the

insert (A) should be positioned as shown in Fig. 20. This

allows for clearance of the blade when the table is tilting.

Fig. 19

Fig. 20

Fig. 21

A table insert blank (B) Fig. 21, is supplied as standard

equipment with your scroll saw and can be used when

cutting very small workpieces to give added support to

the bottom of the workpiece. Cut a slot into the blank and

replace the standard insert (A) with the blank (B). The

slot cut into the blank (B) will only be as wide as the

blade giving maximum support to the bottom of the

workpiece.

CHANGING BLADES

1. WARNING: DISCONNECT MACHINE FROM

POWER SOURCE.

2. Remove table insert (A) Fig. 22, and release blade

tension by pulling tension lever (B) forward, as shown.

Fig. 22

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 59 60

No comments

Delta SM600 User Manual Page 11