Delta SM600 User Manual download pdf (Page 12)

3. Push chuck locking lever (C) Fig. 23, to the rear as

shown. This will release the blade (D) from the upper

chuck (E).

Fig. 23

4. Insert long end (F) Fig. 24, of quickset blade wrench

into hole (G) in lower blade holder. This will align wrench

(H) with blade holder screw (J).

Fig. 24

5. Fig. 25 illustrates the quickset blade changing

wrench (K) engaged with the lower blade holder

assembly. Turn wrench counterclockwise to loosen

screw (J) Figs. 24 and 25, and remove blade from lower

chuck.

6. Insert new blade into the lower and upper blade

holders in the same manner, making certain the blade

teeth are pointing down toward the table.

7. Tighten screw (J) Fig. 26, in lower blade guard

assembly.

8. Push chuck locking lever (C) Fig. 23, to the foreword

position, to lock the blade in the upper blade holder

assembly.

10. Apply blade tension by referring to the following

section "ADJUSTING BLADE TENSION."

Fig. 25

Fig. 26

9. Replace the table insert that was removed in STEP

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 59 60

No comments

Delta SM600 User Manual Page 12