Delta SM600 User Manual download pdf (Page 8)

Fig. 7

5. Position table (A) Fig. 7, on the machine as shown.

Align the two holes in the table trunnions (O) with the two

holes in the base (P) of the machine. NOTE: BEFORE

TIGHTENING THE M6x1x45mm SPECIAL SCREWS

(B) AND M6 LOCKNUTS (C) FIG. 7, MAKE SURE THE

TILT SCALE (D), IS POSITIONED INSIDE POINTER (E)

AS SHOWN. ALSO, DO NOT COMPLETELY TIGHTEN

THE M6x1x45mm SPECIAL SCREWS (B) AND M6

LOCKNUTS (C). TABLE MUST BE ABLE TO TILT

FREELY. Fasten the table (A), to the base (P), using the

two M6x1x45mm special screws (B), and M6 locknuts

6. Disassemble the handle by unscrewing and remov-

ing screw and spring (F), and handle (G) from locking

stud (H), as shown in Fig. 8. Place a M10 flat washer (J)

on threaded end of stud (H).

7. Screw threaded end of stud (H) Fig. 9, with the M10

flat washer (J) through slot in angle of tilt scale (D) and

into tapped hole (K).

8. Place handle (G) Fig. 10, onto locking stud (H) and

fasten with screw and spring (F). Move table (A) to the

horizontal position and lock table (A), by turning handle

(G) clockwise.

Fig. 8

Fig. 9

Fig. 10

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 59 60

No comments

Delta SM600 User Manual Page 8