Delta DTE10T Series Specifications

- 1 - Series Temperature Controller Instruction Sheet Thank you very much for choosing Delta DTE series temperature controller. Please read this

- 10 - INA INB Content Explanation CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 Read/write output 1 value Unit: 0.1 % H1070(H110E)H1071(H120E)H1072(

- 11 - Communication Parameter Setting Content 0 1 2 3 4 5 6 Baudrate 2,400bps 4,800bps 9,600bps 19,200bps 38,400bps 57,600bps 115,200bpsPa

- 12 - ASCII Mode Read Command Read Response Message Write Command Write Response Message Start word ’:’ Start word ’:’ Start word ’:’ Star

- 13 - How to Mount & DIN Rail Size Connect maximum 7 DTC2000 or DTC2001 controllers to DTE by using DIN rail.

- 2 - Specifications Power input 24 VDC, isolated switching power supply Voltage range 90 to 110% rated voltage Power consumption Max. 10 W + 3

- 3 - Input The standard DTE main unit is attached with 4 channels of inputs. You can purchase additional DTE20T or DTE20P to expand the number of

- 4 - Value = 0 Value = 1 Value = 2 Value = 3 OUT1, OUT2** Heating control Cooling control Proportional output Disable output SUB1, SUB2*

- 5 - LED Display PWR: On  DTE is powered. RUN: On  Any of the channel is executing. COM: Flashing  Communication in progress ERR: Indicating e

- 6 -INA + INB input: INA+INB CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 OUT1 control mode 10A8H 10A9H 10AAH 10ABH 10ACH 10ADH 10AEH 10AFH Ala

- 7 - How to Operate 1. Enable the slope function: Write 1234H into the address 47F1H and then 0020H into address 4824H. bits in 4824H Bit7 Bit6

- 8 - Output Limits! Function!The output is limited between the maximum and minimum percentages.  How to Operate Set up relevant parameters usin

- 9 - If there is already a set value in 4824H and you would like to modify it, reset it to 0 before you set up a new value. 2. Set up relevant p