Delta 50-764 User Manual download pdf (Page 9)

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL

THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION

MANUAL.

CASTERS

1. Turn stand (A) upside down, as shown in Fig 1F.

2. Align holes in caster assembly (B) with holes in

plates on stand. Place small 5/16” flatwasher on a

5/16”x3/4” hex head screw. Insert screw through

hole in caster assembly and thread into hole in

stand. Repeat for all holes in all casters.

3. Tighten hardware by hand, then set with a 12mm

wrench.

LEGS TO MOTOR/BLOWER

ASSEMBLY

1. Place motor/blower assembly with the motor down.

(Fig. 2)

2. Place 3/8” (18 mm) flatwasher on knob (A) Fig. 2.

3. Align holes (B) on legs with holes (C) in the mo-

tor/blower assembly. Legs should extend up. Insert

knob through hole (B) in the legs and thread into

hole (C) in the motor/blower assembly. Tighten

knob securely.

4. Repeat steps for all knobs on both legs.

Fig. 1F

Fig. 2

ATTACHING STAND TO LEGS ON

MOTOR/BLOWER ASSEMBLY

NOTE: TWO PEOPLE ARE NEEDED FOR THIS STEP.

Place all four stand posts (A) Fig. 3 into four legs (B) on

motor/blower assembly.

Fig. 3

THIS MACHINE IS HEAVY. USE TWO

OR MORE PEOPLE WHEN LIFTING.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

No comments

Delta 50-764 User Manual Page 9