Delta 50-851 User Manual

INSTRUCTION MANUAL2 H.P. Single-StageDust Collector(Model 50-851)PART NO. 902114 - 07-01-02Copyright © 2002 Delta MachineryTo learn more about DELTA M

10Fig. 253. Three dust intake port caps (D) Fig. 25, are suppliedwith the dust collector. NOTE: These caps should beinserted into the intake ports as

11OPERATING CONTROLSON/OFF SWITCHThe “on/off” switch is located on the side of the motor.To turn the dust collector “ON”, push the start button(A) Fig

The following are trademarks of PORTER-CABLE·DELTA (Las siguientes son marcas registradas de PORTER-CABLE S.A.): Auto-Set®,BAMMER®, B.O.S.S.®, Builder

2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain ha

3ADDITIONAL SAFETY RULES FORDUST COLLECTORSWARNING: FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.1. DO NOT OPERATE THIS MACHINE

4Fig. 2Fig. 3Fig. 21 - Blower and motorassembly2 - Eight-hole rubbergasket3 - Ten-hole rubbergasket4 - Base5 - Intake PortCaps (3)6 - Intake Ports7 -

5Fig. 4Fig. 5Fig. 6Fig. 7ASSEMBLING CASTERASSEMBLIES TO BASE1. Align the holes in swivel caster assembly (A) Fig. 4,with four holes in caster bracket

6Fig. 8Fig. 9Fig. 10Fig. 115. Place ten-hole rubber gasket (J) Fig. 8, on blowerflange (H). Align holes in gasket with mounting holes inblower flange

7Fig. 12Fig. 13Fig. 14Fig. 158. Align mounting holes in drum (N) Fig. 12, withgasket (M), which was assembled in STEP 7. Place a5/16" lockwasher

8Fig. 16Fig. 17Fig. 18 Fig. 1912. Assemble the other end of drum support arm (T)Fig. 16, to base (B). Place a 5/16" lockwasher onto a5/16-18x5/8&

9Fig. 20Fig. 21Fig. 22Fig. 24Fig. 233. Position open end of filter bag (A) Fig. 20, overupper lip of support drum (E). Insert locking band (F) Fig.20,