Delta 50-851 User Manual download pdf (Page 7)

Fig. 12

Fig. 13

Fig. 14

Fig. 15

8. Align mounting holes in drum (N) Fig. 12, with

gasket (M), which was assembled in STEP 7. Place a

5/16" lockwasher onto a 5/16-18x5/8" hex head screw,

insert screw (P) Fig. 13 through chute (K), thread screw

into drum (N) and tighten securely. Repeat this process

for the seven remaining holes.

9. Assemble “U” bracket (R) Fig. 14, to side of drum

(N). Place a 5/16" lockwasher then a 5/16" flat washer

onto the 5/16-18x5/8" hex head screw. Insert the hex

head screw through the hole (S) in the “U” bracket and

the hole in the drum, thread a 5/16-18 hex nut onto the

screw and tighten securely. Repeat this process for the

remaining hole.

10. Align two mounting holes in the top of drum support

arm (T) Fig. 15, with two pre-drilled holes in drum (N).

Place a 5/16" lockwasher then a 5/16" flat washer onto

a 5/16-18x5/8" hex head screw, insert the hex head

screw through the hole (V) in drum support and drum.

Thread a 5/16-18 hex nut onto the hex head screw.

Repeat this process for the remaining hole. NOTE: Do

not completely tighten mounting hardware at this time.

11. Attach the lower dust bag retaining clip (A) Fig. 14A,

to the dust collector drum. Align the two holes (B) in the

retaining clip (A) Fig. 14A, with the two holes in the drum.

Insert a 1/4-20x5/8" hex head screw through the holes in

the retaining clip and the holes in the drum. Place a 1/4"

flat washer onto the screws, and thread 1/4-20 hex nut

on the screws and tighten securely. Repeat this process

for the three remaining sides of the drum.

Fig. 14A

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Delta 50-851 User Manual Page 7