INSTRUCTION MANUAL5 H.P. Dust Collector(Model 50-866 Single Phase)(Model 50-861 Three Phase)PART NO. 902110 - 04-18-02Copyright © 2002 Delta Machinery
10Fig. 23Fig. 24Fig. 25Fig. 263. Assemble six-position filter bag hanger assembly(G) Fig. 23, to the top half of the upper bag support (H).Place a 5/1
11Fig. 27Fig. 28Fig. 29ASSEMBLING DUSTCOLLECTION BAGS TODRUMS1. Insert bag clamp (A) Fig. 27, through the loops of thedust bag (B).3. Clamp the dust c
12Fig. 32CONNECTING MACHINETO POWER SOURCEMODEL 50-866 SINGLE PHASEINSTALLATIONWARNING: Installation by a qualified electrician isrecommended to assur
13Fig. 34Fig. 35MODEL 50-861THREE PHASEINSTALLATIONWARNING: Installation by a qualified electrician isrecommended to assure safe and proper wiring and
14MAINTENANCENOTE: Before any maintenance or service is performed, be sure that unit is disconnected from power source toprevent accidental starting.M
15ACCESSORIESA complete line of accessories is available from your Delta Supplier, Porter-Cable · Delta Factory Service Centers, andDelta Authorized S
The following are trademarks of PORTER-CABLE·DELTA (Las siguientes son marcas registradas de PORTER-CABLE S.A.): BAMMER®,INNOVATION THAT WORKS®, JETST
2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain ha
3IMPORTANT SAFETY RULES FORDUST COLLECTORSWARNING:Basic precautionsshould always be followed when using your dustcollector. To reduce the risk of inju
4UNPACKING AND CLEANINGCarefully unpack the tool and all loose items from the shipping container(s). Remove the protective coating from allunpainted
5Fig. 3Fig. 41. Motor, Fan and Blower Assembly (Hardware for mounting not shown: 5/16" flat washer (4), 5/16" lockwasher (4), 5/16-18 hex nu
6ASSEMBLYASSEMBLING CASTERS TOBASETurn base over. Align four holes in caster (A) Fig. 5, withfour holes at one corner of base (B) and assemble castert
7Fig. 10Fig. 11Fig. 12Fig. 14Fig. 134. NOTE: FOR MODEL 50-866 MAKE SURE THATTHE FRONT OF THE MOTOR ASSEMBLY ISATTACHED TO THE SUPPORT WITH THREEPREDRI
8Fig. 15Fig. 16Fig. 17Fig. 189. Fig. 15, illustrates both drums (K) assembled to thefan and blower assembly (F).ASSEMBLING DRUMSUPPORT POSTS TOBASE AN
9Fig. 19Fig. 20Fig. 21Fig. 22ASSEMBLING INTAKE PORTTO MOTOR AND BLOWERASSEMBLYPlace the intake port (A) Fig. 19, onto the flange ofmotor/blower assemb
Comments to this Manuals