Delta 50-866 User Manual download pdf (Page 10)

Fig. 23

Fig. 24

Fig. 25

Fig. 26

3. Assemble six-position filter bag hanger assembly

(G) Fig. 23, to the top half of the upper bag support (H).

Place a 5/16" lockwasher (I) onto a 5/16-18x1¼" hex

head screw (J), place a special washer (K) (30mm O.D.,

8mm I.D., 3mm thick), onto the screw, insert the screw

through the filter bag hanger and place special washer

(L) (30mm O.D., 8mm I.D., 3mm thick) onto screw.

Thread the screw into the top half of upper bag support.

Assemble the remaining six-position hanger to the other

upper bag support (H) in the same manner.

4. Insert the upper bag support (H) Fig. 24, into the

lower bag support (H), making certain the pin (F) in lower

bag support engages hole in upper bag support.

Assemble the remaining bag support in the same

manner.

5. Position top of filter bags (J) Fig. 24, onto both hanger

assemblies (G) as shown, until all twelve filter bags are

positioned (6 each) on both hanger assemblies.

6. IMPORTANT: Each filter bag (J) Fig. 25, features a

channel (K) in the hem of the bag. This will allow the

filter bag (J) to be positioned and held inside the lip of

six holes in each drum assembly (B). Insert the open end

of each bag (J) Fig. 26, into the hole in the drum

assembly until the channel (K) in the bag is positioned

over the lip of each drum opening as shown. Assemble

the remaining 11 filter bags to the two drums in the

same manner.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Delta 50-866 User Manual Page 10