Delta 50-866 User Manual download pdf (Page 12)

Fig. 32

CONNECTING MACHINE

TO POWER SOURCE

MODEL 50-866

SINGLE PHASE

INSTALLATION

WARNING: Installation by a qualified electrician is

recommended to assure safe and proper wiring and

product operation.

The motor rating for your single phase dust collector is

230 Volts, 5 H.P. Before connecting your dust collector

to an electrical power system, be sure the electrical

system agrees with the motor rating of the tool.

The single phase Model 50-866 Dust Collector is

supplied with a motor and controller; however, it is not

furnished with a power cord or plug. To connect the dust

collector to a power system, proceed as follows:

1. Assemble the control box (A) Fig. 32, to the front of

the side support (H) Fig. 33. Insert sheet metal screws

(B) Fig. 32, through holes in the controller box and

thread the sheet metal screw into the side support and

tighten securely.

2. Bring the power cord (not supplied) up through the

large knockout hole (C) Fig. 32, in the control box (A) and

connect the two power lines to terminals (D) and the

green ground wire to ground screw (E). NOTE: THE

POWER CORD MUST BE INSERTED THROUGH THE

BUSHING IN THE ACCESS HOLE (C), TIGHTEN THE

ACCESS HOLE NUT OVER THE ACCESS HOLE TO

HOLD THE POWER CORD IN PLACE.

3. Reassemble the cover onto the controller box (A)

Fig. 33.

4. The ON/OFF buttons are located at the front of the

control box. To start the machine, push “ON” button (F)

Fig. 33. To stop the machine, push the “OFF” button (G).

Fig. 33

1 2 ... 7 8 9 10 11 12 13 14 15 16

No comments

Delta 50-866 User Manual Page 12