Delta 50-866 User Manual download pdf (Page 6)

ASSEMBLY

ASSEMBLING CASTERS TO

BASE

Turn base over. Align four holes in caster (A) Fig. 5, with

four holes at one corner of base (B) and assemble caster

to base. Place a 5/16" lockwasher (D), then a 5/16" flat

washer (E) on a 5/16-18x5/8" hex head screw (C), insert

the hex head screw through the hole in the wheel caster

and thread the screw into the base. Repeat this process

for the three remaining holes. Assemble the remaining five

casters (A) Fig. 6, to the underside of the base (B) in the

same manner.

Fig. 5

Fig. 6

Fig. 7

Fig. 9Fig. 8

ASSEMBLING SUPPORTS,

MOTOR AND BLOWER

ASSEMBLY TO BASE

1. Turn base over so it is resting on the casters.

2. Assemble two supports (A) Fig. 7, to the threaded

holes at the sides of the base (B). Place a 5/16"

lockwasher (C) on a 5/16-18 x 5/8" hex head screw (D),

and insert the screw through the side support and

thread the screw into the base. Repeat this process for

the remaining screw. Attach the other side support in the

same manner. NOTE: Do not completely tighten

hardware at this time.

3. Assemble two cross-member supports (D) Fig. 8,

diagonally to the two side supports (A). Align the holes

in the cross-member supports (D) with the holes in the

side supports (A). Place a 5/16" flat washer (B) on a

5/16-18 x 5/8" hex head screw (C), insert the screw

through the cross-member support and side support,

and place a 5/16" lockwasher onto the screw and fasten

with a 5/16-18 hex nut (E). Repeat this process for the

remaining hole. Attach the other cross-member support

in the same manner. The cross-member supports (D)

Fig. 9, are shown assembled to the side supports.

NOTE: Tighten hardware at this time.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

No comments

Delta 50-866 User Manual Page 6