Delta AP300 User Manual download pdf (Page 17)

Before any maintenance or service is performed, be sure the dust collector is disconnected from the

power source to prevent accidental starting. All maintenance other than the items recommended in this manual should

be performed by an authorized Delta Service Center.

1. Always disconnect the machine from the power source before performing any maintenance

procedures.

2. The condition of the dust bag should be checked periodically for damage and emptied on a regular basis. Do not

transport the machine with a full dust bag.

3. Clean and apply a dry silicone lubricant monthly to the impeller to remove any dirt or build-up of pitch, gum and

wood shavings.

4. Always make sure that the intake cap (A) Fig. 31, covers the intake port when the hose is not

connected to the machine.

Fig. 31

MAINTENANCE

KEEP MACHINE CLEAN

Periodically blow out all air passages with dry compressed

air. All plastic parts should be cleaned with a soft damp

cloth. NEVER use solvents to clean plastic parts. They could

possibly dissolve or otherwise damage the material.

Wear ANSI Z87.1 safety glasses while

using compressed air.

FAILURE TO START

Should your machine fail to start, check to make sure the

prongs on the cord plug are making good contact in the

outlet. Also, check for blown fuses or open circuit breakers

in the line.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

No comments

Delta AP300 User Manual Page 17