Delta 211 Series Specifications Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 41
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
Chapter 1 Introduction
1-3
DVP201/202/211LC-SL
Load cell module Voltage output
Maximum distance for
connecting a load cell
100 meters
Maximum output current 5 V DC * 300 mA
Allowable load 40~4,010
Averaging weights 100
Common-mode rejection ratio
(CMRR @50/60 Hz)
100 dB
Isolation
Between a digital circuit and the ground: 500 V AC
Between an analog circuit and the ground: 500 V AC
Between an analog circuit and a digital circuit: 500 V AC
Connecting to a DVP series PLC
Load cell modules can be connected to the left side of a PLC. The
modules connected to a PLC are numbered from 100 to 107 according to
the closeness to the PLC.
Operation/Storage
Operation: 0~55°C (temperature), 5~95% (humidity), pollution degree 2
Storage: -25~70°C (temperature), 5~95% (humidity)
Vibration/Shock resistance
International standards: IEC 61131-2, IEC 68-2-6 (TEST Fc)/IEC 61131-2
& IEC 68-2-27 (TEST Ea)
DVP211LC-SL
Electrical specifications for input
terminals
Electrical specifications for output
terminals
Input/Output terminal X0, X1 Y0, Y1, Y2, Y3
Type Digital input Transistor
Form DC (sinking or sourcing) --
Specifications Input current: 24 V DC, 5 mA Voltage specifications: 5~30 V DC
#1
Input impedance 4.7 K --
Maximum switch frequency 10 kHz 1 kHz
Off On > 15 V DC --
Action level
On Off < 5 V DC --
Off On < 20 μs < 100 μs Response
time
On Off < 50 μs < 150 μs
Resistive load -- 0.5 A/output (4 A/COM)
#2
Inductive load -- 15 W (30 V DC)
Maximum
load
Bulb -- 2.5 W (30 V DC)
Note: In order to meet DIN 1319-1, an error needs to be less than or equal to 0.05% at 20 °C + 10 K.
#1: UP and ZP should be connected to a 24 V DC power supply. The current that an output terminal consumes
is approximately 1 mA.
#2: In an NPN mode, ZP is used. In a PNP mode, UP is used.
Page view 5
1 2 3 4 5 6 7 8 9 10 11 ... 40 41

Comments to this Manuals

No comments