Delta PG-30 Installation Manual download pdf (Page 10)

SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS

VISUAL INSPECTION: Before installing the unit, check the

container and machine for damage. A damaged container is

an indicator that there may be some damage to the machine.

If there is damage to both the container and machine, do not

throw away the container. The dishmachine has been inspect-

ed and packed at the factory and is expected to arrive to you

in new, undamaged condition. However, rough handling by

carriers or others may result in there being damage to the unit

while in transit. If such a situation occurs, do not return the unit

to Jackson; instead, contact the carrier and ask them to send

a representative to the site to inspect the damage to the unit

and to complete an inspection report. You must contact the

carrier within 48 hours of receiving the machine. Also, contact

the dealer through which you purchased the unit.

UNPACKING THE DISHMACHINE: Once the machine has

been removed from the container, ensure that there are no

missing parts from the machine. This may not be obvious at

first. If it is discovered that an item is missing, contact Jackson

immediately to have the missing item shipped to you.

LEVEL THE DISHMACHINE: The dishmachine is designed to

operate while being level. This is important to prevent any

damage to the machine during operation and to ensure the

best results when washing ware. The unit comes with

adjustable bullet feet, which can be turned using a pair of

channel locks or by hand if the unit can be raised safely.

Ensure that the unit is level from side to side and from front to

back before making any connections.

PLUMBING THE DISHMACHINE: All plumbing connections

must comply with all applicable local, state, and national

plumbing codes. The plumber is responsible for ensuring that

the incoming water line is thoroughly flushed prior to connect-

ing it to any component of the dishmachine. It is necessary to

remove all foreign debris from the water line that may poten-

tially get trapped in the valves or cause an obstruction. Any

valves that are fouled as a result of foreign matter left in the

water line, and any expenses resulting from this fouling, are

not the responsibility of the manufacturer.

CONNECTING THE DRAIN LINE: The Delta 1200 glass-

washers have a gravity drain (2” NPT connection). All piping

from the machine to the drain must be a minimum 2” NPT and

shall not be reduced. There must also be an air gap between

the machine drain line and the floor sink or drain. If a grease

trap is required by code, it should have a flow capacity of 5

gallons per minute.

Packaged unit should be visually inspected for damage.

Use a pry bar and mallet to remove the hold-down blocks.

Remove any protective plastic prior to installation.

Lower

Raise

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 49 50

Comments to this Manuals

No comments

Delta PG-30 Installation Manual Page 10

Comments to this Manuals

Related products and manuals for Water heaters & boilers Delta PG-30