Delta PG-30 Installation Manual Page 31

  • Download
  • Add to my manuals
  • Print
  • Page
    / 50
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 30
SECTION 5: SERVICE PROCEDURES
WASH MOTOR REPLACEMENT (CONTINUED)
26
7. Turn the motor so that you will have access to the wiring
cover on the back. Be careful not to pull or yank too hard as
the motor is still connected to the unit by way of the power
lines.
8. Take the needlenose pliers and remove the power wires
from the terminals within the motor.
9. The motor should now be free. Replace with a new new
motor by performing the removal steps in reverse.
10. Place the disharge hose assembly back on the discharge
of the pump and tighten down.
11. Lift the assembly into place within the unit, ensuring that
the suction hose is attached and lines up. Move the assembly
so the mounting bracket slides over the mounting studs.
Position the assembly so that the suction hose is not kinked.
21. Replace and tightne down the nuts securing the bracket to
the frame.
Suction hose coming off when moving the assembly.
Lifting up on the motor.
Pulling the discharge hose out.
Removing the assembly mounting nuts.
Loosening the discharge hose clamp.
Page view 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 49 50

Comments to this Manuals

No comments