Delta PG-30 Installation Manual download pdf (Page 7)

SECTION 1: SPECIFICATION INFORMATION

SPECIFICATIONS

Delta 1200

OPERATING CAPACITY (RACKS/HOUR)

GLASSES PER HOUR 1200

OPERATING CYCLE (SECONDS)

TOTAL CYCLE TIME 120

TANK CAPACITY (GALLONS) 3.0

WASH PUMP CAPACITY

WASH PUMP 55 GPM

TEMPERATURES

WASH---°F (MINIMUM) 130

RINSE---°F (MINIMUM) 75

ELECTRICAL REQUIREMENTS

WASH PUMP MOTOR HORSEPOWER 1/10

NOTE: Typical Electrical Circuit is based upon (1) 125% of the full amperage load of the machine and (2) typical fixed-

trip circuit breaker sizes as listed in the NEC 2002 Edition. Local codes may require more stringent protection than

what is displayed here. Always verify with your electrical service contractor that your circuit protection is adequate

and meets all applicable national and local codes. These numbers are provided in this manual simply for reference

and may change without notice at any given time.

RINSE TYPICAL

HEATER TOTAL ELECTRICAL

VOLTS PH HZ RATINGS AMPS CIRCUIT

208 1 60 220V/3KW 15A 15A

230 1 60 220V/3KW 15A 15A

WATER REQUIREMENTS

INLET TEMPERATURE 130°F

GALLONS PER HOUR 10.0

WATER LINE SIZE NPT (Minimum) 1/2”

DRAIN LINE SIZE NPT (Minimum) 1-1/2”

FLOW PRESSURE P.S.I. 20±5

MINIMUM CHLORINE REQUIRED (PPM) 50

MINIMUM IODIPHOR REQUIRED (PPM) 12.5

NOTE: Always refer to the machine data plate for specific electrical and water requirements. The material provided on

this page is for reference only and may be subject to change without notice.

1 2 3 4 5 6 7 8 9 10 11 12 ... 49 50

No comments

Delta PG-30 Installation Manual Page 7