Delta PG-40 Installation Manual Page 28

  • Download
  • Add to my manuals
  • Print
  • Page
    / 50
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 27
Delta 1200 Technical Manual 07610-003-62-15 G
Issued: 10-27-2008 Revised:05-21-2012
SECTION 5: SERVICE PROCEDURES
THERMOSTAT REPLACEMENT
23
Jackson glasswasher machines come equipped with
thermostats to ensure proper ware washing results.
Occasionally, some of these components may need replacing
to maintain optimum performance.
Jackson offers all of the repair parts necessary for
performing this task.
The instructions provided here are for maintenance
personnel only. Unauthorized persons should not attempt any
of the steps contained in these instructions.
Warning: many of the instructions and steps
within this document require the use of tools. Only autho-
rized personnel should ever perform any maintenance
procedure on the dishmachine!
PREPARATION
1. Power must be secured to the unit at the service
breaker. Tag or lock out the service breaker to prevent acci-
dental or unauthorized energizing of the machine.
2. Ensure that incoming water to the machine is
secured either by use of a shut-off valve or disconnecting the
incoming water line.
3. The unit must be drained completely with the drain
stopper removed.
TOOLS REQUIRED
The following tools will be needed to perform this
maintenance evolution:
1. 3/8” Nutdriver
2. 7/16” Nutdriver
3. 7/16” Combination Wrench
4. Needlenose Pliers
5. Phillipshead Screwdriver
TIME REQUIRED
It is estimated that it will take (1) person twenty min-
utes to perform this task, not including all of the items indicat-
ed in the section entitled “PREPARATION”.
IMPORTANT NOTES
1. Read these instructions thoroughly before
attempting this maintenance task. Become familiar with the
parts and what actions need to be taken. This will save time in
the long run!
STEPS
1. Remove the front door.
2. Remove the heater box cover with the 3/8” nutdriver to
expose the heater. Set the cover and hardware to the side.
3. Using the pair of needlenosed pliers (if necessary), remove
the terminals from the thermostat. Be careful not to damage
the terminals or the wires or else they will have to be replaced.
Removing the heater cover.
Removing the terminals.
Page view 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 49 50

Comments to this Manuals

No comments