Delta 36-865 Instruction Manual download pdf (Page 15)

MOUNTING THE VERSA-FEEDER

TO A MACHINE TABLE

Decide on the location you wish to mount the Versa-Feeder

on your machine. Refer to Figs. 44, 45, and 46 for

assistance when mounting the stock feeder assembly to a table saw, jointer, or shaper. To mount the stock feeder

assembly to a machine table:

1. Position the mounting bracket (A) Fig. 35 at your desired location.

2. Mark the location where four mounting holes are to be drilled.

3. Center punch and drill four 3/8" diameter holes at the locations marked in STEP 2.

NOTE: Do not drill through any table ribs or table supports.

4. Fasten the mounting bracket (A) Fig. 36 to the table with four M10 x 30MM hex head screws and lockwashers and

hex nuts, three of which are shown at (B).

Fig. 35

Fig. 36

MOTOR CONTROL SWITCH

To operate the stock feeder, pull out on the knob (A)

Fig. 40. To stop the stock feeder, push in on the knob (A).

OPERATION

OPERATIONAL CONTROLS AND ADJUSTMENTS

Fig. 37

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

No comments

Delta 36-865 Instruction Manual Page 15