Delta 50-875 Type II Instruction Manual download pdf (Page 8)







    

    



The remote control provided with this unit is not

considered a solid-state device.

The Air Cleaner is equipped with a REMOTE CONTROL

(A) Fig.8A.

 The remote requires two (2) AAA batteries (not

supplied). The Battery housing is located underneath

the back cover.

Notice that the remote control has three control buttons

(Fig. 8A): TIME (B), ON/OFF (C), and SPEED (D). These

buttons correspond to the LED sensor panel on the

rear of the machine (K) Fig. 8B.

 When the machine is connected to the power

source, a green light (E) will be activated on the panel.

To activate the blower unit, press the “ON/OFF” button

of Low or “L” on the sensor panel. Press the SPEED

button once, and the machine will run at the high (or

“H” level). Press the SPEED button again, and the

machine will run at the medium speed (or “M”). Press

the SPEED button a third time, and the machine will

return to the Low Speed mode.

To turn the machine off, press the “ON/OFF” button (C)

Fig. 8A.

This unit has a timer that can be set by remote control.

When the “TIME” button (B) Fig. 8A is pressed on the

remote control, the machine will run for 1/2 hour. (An

LED light will show up on the sensor panel (F) Fig. 8B).

Pressing the “TIME” button again will set the machine

to run for one hour. Notice that the light on the sensor

panel has now moved to the 1H location (G) Fig. 8B.

When the “TIME” button is pressed a third time, the

machine will run for two hours. At this point, the green

light will show up under the two hour location (H).

When you press the “TIME” button the fourth time, the

unit will run for four hours. Notice that the indicator

light (J) glows at the four hour mark.

All of these functions can be manually controlled by

using the two buttons on the sensor panel (K) Fig. 8B.



NOTE: The air cleaner may produce a slight odor for the first few hours of operation due to the protective coating

which is applied to internal components. This odor will dissipate and should be disregarded.









a. bench-top sanding applications.

b. circular saw applications.

c. dry wall applications.

d. shop cleaning applications.

e. floor sanding applications.

f. any other application where non-metallic dust is a factor.





The model 50-875 Type II 3 Speed Ambient Air Cleaner with Pleated Filter has an “air flow” indicator (A) Fig. 9A

located on the left side of the unit. To check the filters, turn the unit “ON”. If the indicator points to “green” (B) Fig.

9A, the filters are clean. Clean (or change) the filters when the indicator points to “red” (C) Fig. 9A as follows:

1. Turn the unit “OFF”.

2. Remove the outer first stage filter (A) Fig. 9B by lifting and pulling out on the bottom of the filter. Replace the

first stage filter depending on its condition. When you replace the outer filter, check to see if the filter has an

air flow arrow (A) Fig 9D. If so, point the arrow inward. If the filter does not have an air flow arrow, install the

filter either way.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Comments to this Manuals

No comments

Delta 50-875 Type II Instruction Manual Page 8

Comments to this Manuals

Related products and manuals for Air filters Delta 50-875 Type II