Delta DBS125 Instruction Manual download pdf (Page 9)

USING THE TOOL

Complete all steps of PREPARING THE TOOL before using the tool.

This tool is shipped from the factory with a “single sequential actuation”

trigger. To fire, grip the tool firmly to maintain control, position nose of

tool onto work surface, push the tool firmly against work surface to

depress safety (S) Fig. 24, and squeeze trigger to fire a fastener. Allow

tool to recoil away from work surface as fastener is driven. This “single

sequential actuation” method provides the most accurate fastener

placement.

Disconnect tool from air supply before performing

maintenance, clearing a jammed fastener, leaving work area, moving

tool to another location, or handing the tool to another person.

Clean and inspect tool daily. Carefully check for proper

operation of trigger and safety mechanism. Do Not use the tool unless

both the trigger and the safety mechanism are functional, or if the tool is

leaking air or needs any other repair.

OPERATING INSTRUCTIONS

Fig. 24

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No comments

Delta DBS125 Instruction Manual Page 9