Delta 50-761 Instruction Manual download pdf (Page 10)

Fig. 5

Fig. 4

ATTACHING DUST INTAKE PORTS

Place dust intake port (A) Fig. 7 over intake hole (B)

opposite the motor. Align four holes (C) in the port with

the ones in the motor/blower assembly and fasten with

four M4 sheet metal screws.

Turn unit over so casters are on the ground.

BECAUSE OF THE WEIGHT OF THE

UNIT, MORE THAN ONE PERSON

SHOULD LIFT MOTOR/BLOWER ASSEMBLY INTO

UPRIGHT POSITION.

Fig. 7

ALTERNATE SETUP

The steps so far will assemble the unit with the motor

on top and dust intake ports on bottom, as shown in

Fig 4.

This unit can be assembled with the intake port (B) Fig.

5 in the up position by following the steps in “LEGS

TO MOTOR/BLOWER ASSEMBLY.” The exception is

to place the motor/blower assembly on a flat surface

with the motor (A) Fig. 6 facing up before attaching

legs.

NOTE: BEFORE DOING THE ALTERNATE SETUP,

REMOVE 5/16” HEX HEAD SCREWS FROM HOLES

(B) FIG. 6 IN MOTOR/BLOWER ASSEMBLY AND

PLACE IN HOLES (C). AIR LEAKAGE WOULD

OCCUR IF SCREWS ARE NOT PLACED IN HOLES

(C).

Fig. 6

DISCONNECT MACHINE FROM POWER

SOURCE

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Delta 50-761 Instruction Manual Page 10