Delta 66-750 Instruction Manual download pdf (Page 21)

21-ENG D26269

STORAGE

Before you store the air compressor, make sure you do the following:

1. Review the "Maintenance" section on the preceding pages and perform

scheduled maintenance as necessary.

2. Set the On/Auto/Off lever to "OFF".

3. Close the globe valve.

4. Remove the air tool or accessory.

5. Open the globe valve and allow the air to slowly bleed from the air tank

until tank pressure is approximately 20 psi.

6. Drain water from air tank by opening drain valve (counter-clockwise) on

bottom of tank.

Water will condense in the air tank. If not drained, water

will corrode and weaken the air tank causing a risk of air

tank rupture.

7. After the water has been drained, close the drain or drain valve.

NOTE: If drain valve is plugged, release all air pressure. The valve can then be

removed, cleaned, then reinstalled.

8. Protect the air hose from damage (such as being stepped on or run over).

To Replace Belt

Serious injury or damage may occur if parts of the body

or loose items get caught in moving parts. Never

operate the unit with the belt guard removed. The belt guard should be

removed only when the compresor is unplugged.

1. Place the ON/AUTO-OFF lever in the OFF position.

2. Unplug compressor.

3. Remove the front of the belt guard by disengaging the snaps. Insert a flat

bladed screwdriver at each snap location and pry the beltguard apart.

4. Loosen the wing nut on hold

down plate and tilt motor to allow

for easy removal or installation of

the belt.

5. Remove belt.

6. Replace belt. NOTE: The belt

must be centered over the

grooves on the flywheel and

motor pulley.

7. Turn the wing nut on the hold

down plate until it makes contact

with the washer, plus one additional turn.

8. Replace the belt guard.

Wing Nut

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 29 30

No comments

Delta 66-750 Instruction Manual Page 21