Delta 20-330 Instruction Manual download pdf (Page 17)

17 - English

CHANGING BAND SAW FROM

HORIZONTAL TO VERTICAL POSITION

Your saw can be changed to the vertical position for

notching, slitting or contour work as follows:

Disconnect machine from power source.

1. Move the cutting arm to the vertical position and

lock in place with the arm positioning lever (C)

Fig. 32. Stop screw (A) Fig. 32 should bear against

base casting when arm is in the vertical position. If

adjustment is needed loosen lock nut (B) and adjust

screw (A).

2. Remove two screws (C) and bearing cover plate (D)

Fig. 33.

3. Assemble the vertical table (E) to the guide bracket

using the two screws (C) that were removed in

STEP 2, as shown in Fig. 34.

4. Assemble one end of the table support bracket

(G) Fig. 35 to the table using a 1/4-20x1/2" flat

head screw and 1/4-20 nut (H) and the other end

underneath the guide bracket lock knob (J), as

shown in Fig. 35.

Fig. 32

Fig. 33

Fig. 34

Fig. 35

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 63 64

No comments

Delta 20-330 Instruction Manual Page 17