Delta 36-600 User Manual download pdf (Page 5)

ASSEMBLY INSTRUCTIONS

When mounting the T-Square

Fence System to table saws that have been equipped with original equipment fence, guide

rails and open grate or stamped steel extension wings, remove the fence, front and rear guide rails and right extension

wing from the saw and assemble the T-Square

Fence as follows:

ASSEMBLING FRONT AND REAR RAILS

1. DISCONNECT THE SAW FROM THE POWER SOURCE

FOR DELTA SAWS ONLY

(Except Models 34-670, 36-380 and 36-600)

2. Align the two holes (E) Fig. 6, in the front rail (C) with the two through holes in the saw table and fasten the rail (C) to the

table saw using the two 3/8-16 x 1-1/4” long flat head screws, flat washers, lock washers and hex nuts supplied. Do not

completely tighten the mounting hardware at this time. It is not necessary to use clamps to hold the front rail to the saw

table. On Delta saws that are equipped with a sheet metal left extension wing, fasten the front rail (C) to the extension

wing using the remaining 3/8-16 x 1-1/4” long flat head screw, lock washer and hex nut supplied through hole (F) in the

front rail

FOR ALL OTHER TABLE SAWS

(Including Delta Models 34-670, 36-380 and 36-600)

3. Raise saw blade (A) Fig. 7. Place a straight edge (B) against right side of saw blade extending out over front of saw

table as shown. Position front rail (C) against front edge of saw table and lightly clamp in place using bar clamps (D). Align

the notch (E) in front rail (C) with right side of saw blade using the straight edge (B) as shown, and tighten bar clamps (D).

4. Figure 7 illustrates the front rail (C) clamped to the front edge of the saw table.

Fig. 6

Fig. 7

NOTE: On Contractor’s saws made prior to 1988,

the two mounting holes in the front edge of the

saw were threaded. It is necessary to drill out the

threads with a 7/16” drill bit and use the hard-

ware provided as indicated in step 2.

1 2 3 4 5 6 7 8 9 10 ... 14 15

No comments

Delta 36-600 User Manual Page 5