Delta 36-979 Instruction Manual download pdf (Page 8)

Fig. 18

1. For rapid adjustment of the work support plate (A) Fig. 19, toward or away from the saw blade, loosen levers (B) and (C)

and move jig (D). Tighten levers (B) and (C).

2. You can fine-adjust the work support plate (A) Fig. 19, by loosening the lever (B) and rotating the knob (E) until plate (A)

is at the desired position. Tighten the lever (B) Fig. 19.

3. To tilt the vertical work support plate (A) Fig. 19, loosen the lock lever (F), tilt vertical work support plate to the desired

angle, and tighten lock lever (F).

4. To adjust backstop (G) Fig. 20, for angle tenons, loosen lock lever (H), tilt backstop (G) to the desired angle and

tighten lever (H).

IMPORTANT: The tenoning jig is not equipped with a bevel scale for the positioning of the backstop (G) Fig. 20 or the support

plate (A) Fig. 19. Cut the workpiece to the desired angle prior to the jig set up and use it as the angle reference.

Disconnect the Machine from the Power Source!

Fig. 19

11. Turn the screw (M) Fig. 17 clockwise until it bottoms to prevent the vertical work-support plate (F) from accidentally being

moved into the blade. Tighten the nut (L).

12. Loosen the screw (Y) Fig. 19, and adjust the pointer (Z) to the “1/8" mark on scale.

Fig. 17

Fig. 20

OPERATION

OPERATIONAL CONTROLS AND ADJUSTMENTS

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No comments

Delta 36-979 Instruction Manual Page 8