Delta 36-R31X Instruction Manual download pdf (Page 15)

The Unisaw is supplied with a dust chute connector to

provide a means of connecting a 4" diameter dust

collector hose to the machine. Align the four holes in the

dust chute adapter (A) Fig. 37,with the four holes in the

back of the saw cabinet (B) and attach the dust chute

adapter with four #10 x 1/2" sheet metal screws.

DO NOT MOUNT THE DUST CHUTE

ADAPTER UNLESS A DUST

COLLECTION SYSTEM IS USED IN CONJUNCTION

WITH THE SAW.

2. Place the motor cover (A) Fig. 34 in the opening of

the Unisaw as shown. Place the rear motor cover clips

inside the motor opening and push the front of the motor

cover until all four motor cover clips are engaged with the

motor cover opening in the Unisaw.

3. Align the hole (B) Fig. 35 in the bottom of the motor

cover with the hole in the side of the saw cabinet. Place

a 1/4" flat washer on a 1/4-20x5/8" hex head screw.

Insert screw through hole in motor cover and thread

screw into hole in side of motor cabinet and tighten

securely.

4. Fig. 35 shows the motor cover attached to the

Unisaw.

NOTE: TO REMOVE THE MOTOR COVER, REMOVE

THE 1/4-20x5/8" HEX HEAD SCREW (B) FIG. 35, AND

PUSH MOTOR COVER TO ONE SIDE FIRMLY TO

DEPRESS CLIPS, AND PULL MOTOR COVER OFF.

Fig. 34

Fig. 35

RIP FENCE

HOLDER BRACKETS

Assemble the rip fence holder brackets (A) and (B) Fig.

36, to the four holes located in the left hand side of the

saw cabinet using four #10 x 1/2" sheet metal screws

supplied.

Fig. 36

Fig. 37

The miter gage and arbor wrenches can be stored in the

slots provided in the motor cover, as shown in Fig. 37A.

Fig. 37A

MITER GAGE AND WRENCH STORAGE

DUST CHUTE ADAPTER

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

No comments

Delta 36-R31X Instruction Manual Page 15