Delta RS830 Instruction Manual download pdf (Page 9)

ASSEMBLY

WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL

THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION

MANUAL.

LEGS TO SAW BASE

1. Loosen lock knob (A) Fig. 8, and move cutting-head

(B) to the rear position as shown. Then tighten knob (A).

2. IMPORTANT: Make certain the cutting-head is

clamped securely at the back of the track arm.

Fig. 8

3. Place Radial Arm Saw on its back and assemble legs

corner of saw base (D) using sixteen 5/16-18 x 5/8"

carriage head screws, 5/16" flat washers, 5/16" external

tooth lockwashers, and 5/16-18 hex nuts. Place flat

washer on bolt. Insert bolt through holes then assemble

lockwasher and nut. Hand tighten, hardware at this time

but do not completely tighten.

4. Stand the saw in the upright position and securely

tighten all stand hardware.

Fig. 9

WRENCH HOOK TO

SAW BASE

Assemble wrench hook (K) Fig. 10, to the front right

(as shown), or back left, side of saw base (D), using two

#10 x 1/2" sheet metal screws.

Fig. 10

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 29 30

No comments

Delta RS830 Instruction Manual Page 9