Delta 36-L336 Use and Care Manual download pdf (Page 33)

BEVEL INDICATOR CABLE (E) Fig. 83: Keep the cable (E) and mating slot (P) free of dust and debris buildup. Blow out

area regularly with compressed air.

AS NEEDED, GREASE THE WORM GEARS (F) and (G) Fig. 84: Keep the worm gears free of dust and debris buildup.

Blow out area regularly with compressed air. Use a lithium-based multipurpose grease as needed on these gears. When

greasing gears, be careful and do not get any grease on the bevel indicator cable (E) Fig. 83.

CLEAN SAWDUST BUILDUP OUT OF CABINET PERIODICALLY: An access panel (H) Fig. 85 in the front of the saw

helps with this. Open the panel — by twisting the knob (I) — and clean out sawdust buildup periodically. NOTE: Debris

can also be removed from the Unisaw from below the throat plate, inside the dust port and from behind the motor cover.

FIG. 83

FIG. 87

FIG. 84 FIG. 85

To reduce the risk of injury, turn saw off

and disconnect power before cleaning or servicing.

REPLACING BELTS

1. Open the motor cover (J) Fig. 86.

2. Place a piece of wood (K) Fig. 86 between the motor

and the saw cabinet.

NOTE: You may need to raise the saw arbor to insert the

wood. Lower the saw arbor until the motor contacts the

wood.

3. Loosen the bolt (L) Fig. 87. Lower the saw arbor to

remove tension from the belts (M). Tighten the bolt (L).

4. Raise the saw arbor slightly and remove the wood (K)

Fig. 86.

5 . Lower the saw arbor to its previous position. Remove

the belt (M) Fig. 87 from the pulleys.

6. Install the new belt, in the grooves of the arbor pulley

(N) Fig. 88, and the motor pulley. (NOT SHOWN.)

7. Loosen the bolt (L) Fig. 87, and carefully let the motor

rest on the belt.

8. Correct belt tension is indicated with a 1/4" (6.4 mm)

deflection in the center span of the pulleys, using light

finger pressure. Tighten bolt (L) Fig. 87.

9. Ensure the cable (O) Fig. 87 is oriented as shown.

FIG. 86

FIG. 88

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 107 108

No comments

Delta 36-L336 Use and Care Manual Page 33