Delta DT2200P Instruction Manual download pdf (Page 13)

13- ENG

D25130

4. Connect high pressure hose to

pump outlet.

5. Connect water source to pump

inlet.

NOTE: Water source must provide

a minimum of 5 gallons per minute

at 20 p.s.i.

6. If you are applying a chemical or

cleaning solution, See How To

Siphon Chemicals/Cleaning

Solvents in Operation section of

this manual.

7. Turn water source on.

NOTE: Make sure water supply is

turned on.

8. Start engine, refer to engine

manual for correct procedure.

If the engine does

not start after two

pulls, pull the trigger to relieve the

pressure.

9. Depress trigger on gun to start

water flow. Release trigger to

stop water flow.

10. Adjust nozzle spray for the task

being performed. See How To

Use Wand instructions in this

section.

DO NOT let hoses

come in contact

with very hot engine muffler during

or immediately after use of your

pressure washer.

Water

Source

High

Pressure

Hose

Filter Screen

BEFORE STARTING

Read and understand all Important

Safety Instructions in the front of

this manual and the following

Cautions and Warnings before

starting the pressure washer.

• Never fill fuel tank completely.

Fill tank to 1/2" below bottom

of filler neck to provide space

for fuel expansion. Wipe any

fuel spillage from engine and

equipment before starting

engine.

• Never fill fuel tank indoors.

Never fill fuel tank when engine

is running or hot. Do not

smoke when filling fuel tank.

• Never run engine indoors or in

enclosed, poorly ventilated

areas. Engine exhaust con-

tains carbon monoxide, an

odorless and deadly gas.

• Never turn water supply off

while pressure washer engine

is running or damage to pump

will result.

• DO NOT use hot water, use

cold water only.

• DO NOT stop spraying water

for more than two minutes at a

time.

1. Add fresh high quality unleaded

gasoline with a pump octane rat-

ing of 86 or higher. Do not over-

fill. Wipe up spilled fuel before

starting the engine. Refer to

engine manual for correct proce-

dure.

2. Check engine oil. Refer to the

engine manual for correct proce-

dure.

NOTE: There will be a slight

amount of oil in the engine form

factory tiesting.

3. Verify the filter screen is in water

inlet of pump, as shown.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 21 22

Comments to this Manuals

No comments